Help in Programming of My First AVR Atmega8 using Ponyprog

2 posts / 0 new
Last post
Author
Message
#1
  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

Hi guys,

I am using AVR ISP Parallel Port programmer circuit diagram (see attachment) and ponyprog latest version which support Atmega8,

After setup of Ponyprog like LPT > AVR ISP I/O and first connect Atmega8 and tried to write some program, read, verify and erase. But every time i got the same message of "Device Missing or Unknown Device (-24)".

i did many thing, and checked The status of SCK, MOSI and MISO with a logic Probe and found some One and Zeros

Can any one help me about this as i am not getting success in programming of my fisrt controller.

Thanks and Regards,
masterleous

Attachment(s): 

  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

There is massive load of problems reported with these types of ParallelPort programmers. See the link in my signature. Take some time to read it.

Nard

Dragon broken ? Or problems with the Parallel Port Programmer ? Scroll down on my projects-page http://www.aplomb.nl/TechStuff/TechStuff.html for tips