Energy Meter Project - ATM90E36A

Go To Last Post
5 posts / 0 new
Author
Message
#1
  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

Hello Freaks...
How long?

 

Freaks I'm looking a project for a Energy Meter board for poly-phase measurement. I'm looking for a partner in this project. 

I'm with the ATM90E36A dev board but I'm out of time to work on it :(  Then the ideia is to use the ATM90E36A as measurement IC.

Regards,

Bruno Muswieck

  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

"Project" and "Partner" are not well defined.

 

 To do testing and development, you will need 3 phase programmable V/I sources.  The V<->I phases are easily rotated for PF. The V is at low current, and the I at low voltage, so the power used by the equipment is low.  To evaluate harmonic response, you will need the ability for arbitrary wave form generation too.  Add in EMC testing, you need major stuff. Equipment is $$$$$.

 

It all starts with a mental vision.

Last Edited: Mon. Jul 18, 2016 - 03:35 PM
  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

Partner... Someone that already had a working hardware...

Carlson why you need all these stuff if the ATM90E36A is an energy meter IC? You need to do the hardware for it and read the values...

Regards,

Bruno Muswieck

  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

As they say in Shark Tank, I am out. The equipment is need for calibration, and design verificaton. Best of luck...

It all starts with a mental vision.

  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

Carlson, there is a lab that do certification in these type of equipment. The certification needed in Brazil. What type of Equipamentos they have, I don't know, but for sure I will send the equipment for this lab to test, more than once.

Don't worry, there is no shark tank.. 

Regards,

Bruno Muswieck