CW keyer with 4bit LCD Display

1 post / 0 new
Author
Message
#1
  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

CW Keyer Using 90s8515 . Port A Pin 7 and 6 are Dit and Dash. Pins 0 and 1 are speed up and speed down. In wpm

LCD displays current WPM and Delay Spacing in ms. Port C pin 0 is Key out. Interfaces nicely with my little Pixie II RF transceiver. With a 5 volt regulator for the Atmel and an isolation transistor for the keying line. The Pixie II runs at 9v.

Any feedback is appreciated.

Mrfixit

KC7EIP

[/url]