I'm trying to run an example Blinking LED using a ATTiny25 being programmed by an USBasp, it does let me (upload the firmware) but nothing happens (the pin doesn't toggle). I'm configuring pin 5 as the toggling pin. I attach an image where you can see I'm selecting the USBasp as the programmer and the ATTiny25 as the processor, also the assembly code from the program (log.txt) and another image from the messages I get once I finish uploading the FW using Arduino IDE.
I'm using Arduino IDE 1.8.5
I have tried also AVRDUDESS 2.4 IDE and I get no errors after loaded the FW. Image attached.
Another comment, I have done the same procedure in 2 USBasp programmers just to discard the programmer HW.
I'm running out of ideas, any comment is highly appreciated.