Atmel-ICE for AVR/SAM blown Vregulator

Go To Last Post
5 posts / 0 new
Author
Message
#1
  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

Hi,

A powered Hub just blew the vreg on my ICE. Seems to be a 6 pin Syncronous buck regulator about 2 x 2mm. I can see VIN on pin 4 and 5. Pin one to the inductor, not sure about the rest.

Anyone have any clue about this part. I searched for a schematic but no luck.

Replacement a week away but I need to get going asap.

Thanx

Andre

  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

turbotronic wrote:
I searched for a schematic but no luck.
Maybe all there is :

Atmel-ICE

Architecture Description

http://www.atmel.com/webdoc/GUID-DDB0017E-84E3-4E77-AAE9-7AC4290E5E8B/index.html?GUID-9B532A87-65FB-47FB-9572-A406F9A71F46

Try removing the buck IC then supplying approx 3Vdc to the buck's inductor.

 

"Dare to be naïve." - Buckminster Fuller

  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

That looks like it might be a TPS40222 !?!

 

Compare the datasheet schematic to your board.

 

Jim

 

  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

Hi there! So did you solve the problem?

I have the same problem)

  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

Hi,

its almost one year ago but I recently had the same problem.

I figured out its a TPS62240. The pinning fits + the datasheed on page 20 says "device marking: BYJ"

The most important, it works.

 

Maybe someone else needs that information to fix a blown ATMEL ICE.