ATmega328P-XMINI PCB set up with Atmel studio 7

1 post / 0 new
Author
Message
#1
  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

I have not been able to 'seamlessly' set up my XMINI with atmel studio 7. When I plug in the device it is immediately recognized by atmel studio, however when i actually build and run some code I'm prompted with these messages:

 

"Failed to launch debug session with debugWIRE. This could be caused by reset line circuitry or siabled debugWIRE interface. Make sure that the reset line is free before continuing. Do you want to use SPI to enable the WEN fuse?"

*click yes*

"Failed to enable DW: Failed to enter programming mode. ispEnterProgMode: Error status received: Got 0xc0, expected 0x00 (Command has failed to execute on the tool)"

 

Ideally I would like to use Geany to build and run code for this device but the set up seems a little complicated

Last Edited: Mon. Dec 11, 2017 - 04:18 PM