UC3C PWM Question

3 posts / 0 new
Last post
Author
Message
#1
  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

I read though the PWM module in the datasheet and it doesn't mention this and I didn't see anyone ask so here goes.

In my project, I only required 1 of the 2 PWM channel output signals, by that I mean I only required the High line and not the Low line. Is it possible to not configure that pin to go to PWM module and use it for another purpose or will this break things?

I haven't tried it as I'm still designing my board and the only dev board I have is a UC3L0 which doesn't have the same PWM module. So I wanted to confirm this so I can run traces elsewhere if I can.

Thanks!

  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

wedgen wrote:
In my project, I only required 1 of the 2 PWM channel output signals, by that I mean I only required the High line and not the Low line. Is it possible to not configure that pin to go to PWM module and use it for another purpose or will this break things?

Yes, there is no problem doing this.

Letting the smoke out since 1978

  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

Awesome, Thanks for the info.