Proud recipient of a new ATMEL ICE today. Been using AS7 in simulator mode for a while on the 328p. Now i want to use the ICE to step through my code live on a Nano.
been doing some reading on this forum and found a post from a few years back about using the debug wire through the 6pin. The post was using the UNO,
I am trying to find where to make the bridge. Do i just have to get rid of the cap on the reset circuit? or do i have to pop the resistor too?
I have the Eagle file and schematic and i found the C2 cap identified in the attacked photo with a clip from the schematic also.
Am i going in the right direction, just popping off Cap 2?