Need help for SPI

Go To Last Post
6 posts / 0 new
Author
Message
#1
  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

I'm willing to use SPI EEPROM IC AT25010. Can anyone tell me how to send and receive data from EEPROM from a particular address?
plz help.

Last Edited: Tue. Nov 21, 2017 - 10:42 AM
  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

I guess the datasheet has the command set covered?

Hans-Christian

  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

it says while writing to control register of EEPROM IC during read and write cycle, we must write A8 bit in opcode. help...........

  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

sabale.ashish wrote:
it says while writing to control register of EEPROM IC during read and write cycle, we must write A8 bit in opcode. help...........

Which MCU? AVR32?

If its general Q about EEPROM, try the general electronics forum.

-drt

  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

Ashish I have same query . How you resolved it ?

  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

Don't hold your breath.  The OP hasn't been active here for almost 9 years.

 

Don't resurrect old threads.  Stick to the thread you already have:

http://www.avrfreaks.net/forum/spi-interfacing-at25010a-chip-issue

 

 

"Experience is what enables you to recognise a mistake the second time you make it."

"Good judgement comes from experience.  Experience comes from bad judgement."

"When you hear hoofbeats, think horses, not unicorns."

"Fast.  Cheap.  Good.  Pick two."

"Read a lot.  Write a lot."

"We see a lot of arses on handlebars around here." - [J Ekdahl]

 

Topic locked