How do we use Atmel Data Protocol?

Go To Last Post
3 posts / 0 new
Author
Message
#1
  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

Does anyone know how to use the Atmel Data Protocol (ADP) for sending data over USART to be plotted in the Data Visualizer? I've been looking at this guide but it is a bit confusing and I can't find any example code. The guide says to open an example project using File -> New -> Atmel Start Example Project​, ​and selecting the ​ADP Hello Example ​project, but I can't actually open the project because I don't have CMSIS installed. I tried to install CMSIS 4.2.0 through the Device Pack Manager, but there was an error installing the pack.

 

Does anyone have example code that illustrates how to use ADP? Or does anyone know why the CMSIS installation would fail?

 

Thanks

 

Last Edited: Sat. Apr 8, 2017 - 08:01 PM
  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

As you are talking about CMSIS I'll move the thread to the ARM side of the forum.

John Samperi

Ampertronics Pty. Ltd.

www.ampertronics.com.au

* Electronic Design * Custom Products * Contract Assembly

  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

mdmosley1 wrote:
... and I can't find any example code.
http://start.atmel.com/#examples/ADP

 

"Dare to be naïve." - Buckminster Fuller