Folks, I bought a couple of Chinese cloned Arduino Nanos with the CH340 USB chip on them. Following a video on YouTube, I downloaded the USB driver, loaded the ISP software onto the Nano (ATMEGA328P) from the Arduino IDE, connected the wires from the Nano to an ATtiny85, and successfully programmed it to blink an LED.
I want to program the ATtiny in assembler, which is much better supported in Studio-7, but I'm a bit mystified how to make Studio-7 transfer the hex file to my ATtiny via the ArduinoISP.
Could somebody give some pointers please? You may need to be a bit explanatory - I've already tried several YouTube-based instructions, but so far without success - so a bit of hand-holding wouldn't go amiss - something at the level of "Mickey's long hand is pointing to ...". I've about got to grips with writing and debugging ASM in Studio-7, but there's a lot about its setup and configuration that doesn't make much sense to me yet.