AVR XMEGA-A1 XPlained - timeout error

Go To Last Post
4 posts / 0 new
Author
Message
#1
  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

Hi Guys,

 

 

I have a problem in fact my microcontroller is not working.

If I keep pressing the LED0 button and then run the program I always get a timeout error.

The LED on the microcontroller shines then red. When I press the LED0 button

keep should actually the microcontroller reset, what the microcontroller does not do.
I tried it with the program Flip, but it did not work.

Thank you very much in advance for your answer.

 

Attachment(s): 

Last Edited: Tue. Jan 10, 2017 - 09:29 PM
  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

If you are trying to activate the bootloader in the XMEGA128A1, you need to hold down PB0 while you apply power to the board (attach the USB cable).

 

Greg Muth

Portland, OR, US

Atmel Studio 7.0 on Windows 10

Xplained/Pro/Mini Boards mostly

 

 

  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

I have already tried this, it does not work. 

Thank you for your quick response.

  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

Has the XMEGA128A1 been programmed by an actual programmer and/or debugger (Dragon, ICE, etc.)?  This typically erases the boot loader. 

Greg Muth

Portland, OR, US

Atmel Studio 7.0 on Windows 10

Xplained/Pro/Mini Boards mostly