Recent Discussions

RSS

Posted by jgmdesign on Sat. Jan 24, 2015 - 03:08 AM
They should rig the forum software so a dude that makes a post cant moderate the thread. Of else rig the forum software so if a modeator makes a post, all the...
Posted by jodis188 on Sun. Jan 25, 2015 - 03:24 PM
Hi Everybody, I often used 16bits macro with Atmel assembler (asm files). For example : .MACRO LDI16 ldi @0L,low(@1)        ;...
Posted by LOSTISLAND on Sun. Jan 25, 2015 - 02:29 PM
Hi all ,  For short range (less than one meter) LF(low frequency like 125Khz) communication is precise but expensive It has it's own benefits too (there...
Posted by PhillyNJ on Sun. Jan 25, 2015 - 01:40 AM
valusoft wrote:   I make sure that the "via" coincides with a through hole component such as a resistor, diode, small bodied capacitor or I simply use a...
Posted by 2013BRZ on Wed. Jan 21, 2015 - 05:49 AM
Just an observation.  If you ran the HV power on the top of the board rather than the bottom you would be able to run all the digit drives in a much...
Posted by Clintonbrits on Thu. Jan 22, 2015 - 07:07 AM
I guess "first" is a bit ambiguous here - it would be better to say "most significant" to avoid any doubt

Buzzing Topics (Last 6 Months)

RSS

Posted by Michael@Atmel on Tue. Aug 26, 2014 - 12:04 AM
did you check the tutorials forum section. There is an excelent thread there about how to do this. It might be handy for future use.   my first guess is...
Posted by Hugh Aguilar on Fri. Oct 24, 2014 - 02:10 AM
Moderators - stop this train wreck now - please!
Posted by mado88 on Mon. Nov 10, 2014 - 03:38 PM
Clawson has true,   I was designed some peripheral boards for lifts - and it is not so simply. There are a lot of standards, norms and regulations. Lift...
Posted by dominicmluciano on Tue. Nov 11, 2014 - 05:42 PM
Hi there,     If the purpose of the project is to find the maximum current you can draw from a USB port then you will need to place a very low value...
Posted by asking on Fri. Aug 15, 2014 - 08:35 PM
About a dozen messages ago, Lee askd you if the a/d reading was Nice and Smooth 0x000 to 0x7ff with a pot or something besides the current sensor. If it is,...
Posted by jgmdesign on Sat. Jan 3, 2015 - 04:12 PM
John_A_Brown wrote: Of course they pay off. Take an extreme case. You're only at home on Christmas day. Do you leave the heating at 21 C all the year round, or...