Recent Discussions

RSS

Posted by naqirizvi on Fri. Jan 30, 2015 - 09:01 AM
Below is Programmer Isp image that is showing fuse of my controller. I searched in data sheet but sorry i wasnt able to find default value of clock. If my MCU...
Posted by hemaltandel on Wed. Oct 1, 2014 - 04:54 PM
Hi Alex!   If it is possible, could you explain me how correctly to organize ZCL_CHARACTER_STRING_DATA_TYPE_ID attribute in ZCL? For example, I have...
Posted by Gandalf22 on Thu. Jan 29, 2015 - 05:08 PM
As suggested I increased to operation speed of the ATTINY. and indeed my "strange behaviours are gone. Slowing down the pulse stream (< 22Khz) was not an...
Posted by pulli00 on Thu. Jan 29, 2015 - 09:39 AM
pulli00 wrote:The microcontroller gets data (16 bit) via SPI. There is no dangerous voltage ?! Unless the SPI is isolated, there is a strong risk that that SPI...
Posted by Vindhyachal Takniki on Fri. Jan 30, 2015 - 11:58 AM
I have to measure strain & circuit is attached. I am using ADS1246 to measure strain, its a 24 bit adc from TI. For 1K SG 1. SG nominal = 1000 ohms , with...
Posted by Rohalamin on Tue. Jan 27, 2015 - 04:55 PM
DO1THL wrote:   ... and, don't post everything you have read on the internet here in avrfreaks. I have a question. why can I always see a type of hatred...

Buzzing Topics (Last 6 Months)

RSS

Posted by Michael@Atmel on Tue. Aug 26, 2014 - 12:04 AM
did you check the tutorials forum section. There is an excelent thread there about how to do this. It might be handy for future use.   my first guess is...
Posted by Hugh Aguilar on Fri. Oct 24, 2014 - 02:10 AM
Moderators - stop this train wreck now - please!
Posted by mado88 on Mon. Nov 10, 2014 - 03:38 PM
Clawson has true,   I was designed some peripheral boards for lifts - and it is not so simply. There are a lot of standards, norms and regulations. Lift...
Posted by dominicmluciano on Tue. Nov 11, 2014 - 05:42 PM
Hi there,     If the purpose of the project is to find the maximum current you can draw from a USB port then you will need to place a very low value...
Posted by asking on Fri. Aug 15, 2014 - 08:35 PM
About a dozen messages ago, Lee askd you if the a/d reading was Nice and Smooth 0x000 to 0x7ff with a pot or something besides the current sensor. If it is,...
Posted by jgmdesign on Sat. Jan 3, 2015 - 04:12 PM
John_A_Brown wrote: Of course they pay off. Take an extreme case. You're only at home on Christmas day. Do you leave the heating at 21 C all the year round, or...