Recent Discussions

RSS

Posted by JimEli on Sun. Dec 21, 2014 - 09:26 PM
I wondered the same thing.    All the Arduino bootloaders come with the source code.    There are no secrets.   If you want...
Posted by AdityaAVR on Tue. Dec 16, 2014 - 10:00 AM
Assuming ISP, pretty easy, actually.  Start with a very slow (< 1 kHz) ISP clock, and fetch the device signature.  If it matches the expected...
Posted by bobgardner on Thu. Dec 18, 2014 - 08:50 PM
I would use a n/e/s/w magnet.
Posted by theincride on Sun. Dec 21, 2014 - 07:40 PM
Ok, I'll jump in, I have used all three methods (RS contact cleaner, rubbing alcohol applied using a q-tip, and WD40) all with equal results on both tube and...
Posted by dhanushgowda on Sun. Dec 21, 2014 - 09:02 PM
Incidentally,    only an Indian dev board could omit a dedicated ISP header. Perhaps between the heat sink and the JTAG?   Hard to tell,...
Posted by XgN on Mon. Dec 22, 2014 - 10:18 PM
Hello, I'm begginer in this microcontrollers science. Maybe anyone could help me to find out what bits are nessessary for this project to get the Tiny15 work...

Buzzing Topics (Last 6 Months)

RSS

Posted by Michael@Atmel on Tue. Aug 26, 2014 - 12:04 AM
clawson wrote: Maybe its just me, but clicking on any links that I've found using google to "old" forum content just end up going to the home page of the new...
Posted by Hugh Aguilar on Fri. Oct 24, 2014 - 02:10 AM
Moderators - stop this train wreck now - please!
Posted by mado88 on Mon. Nov 10, 2014 - 03:38 PM
Clawson has true,   I was designed some peripheral boards for lifts - and it is not so simply. There are a lot of standards, norms and regulations. Lift...
Posted by ka7ehk on Fri. Jul 11, 2014 - 08:29 PM
Often a decaying average is enough. But if you do not want to have any historical data after a given number of sampls, the simple moving average is better...
Posted by dominicmluciano on Tue. Nov 11, 2014 - 05:42 PM
valusoft wrote:   microcarl wrote:    Two amplifiers, each with a total gain of approximately 27 would be nearly perfect: G = 5V / 185mV...
Posted by asking on Fri. Aug 15, 2014 - 08:35 PM
About a dozen messages ago, Lee askd you if the a/d reading was Nice and Smooth 0x000 to 0x7ff with a pot or something besides the current sensor. If it is,...