Recent Discussions

RSS

Posted by ASMManiac on Fri. Dec 19, 2014 - 12:10 PM
Hi Simonetta,   That is pretty much correct. As i replied to David i'm quite certain that the data originates from the Arduino I2C scanner rather than the...
Posted by microcarl on Sat. Dec 20, 2014 - 09:53 AM
 or better still Italo/Australian.....
Posted by Nawfal on Thu. Mar 13, 2014 - 02:38 PM
I'm trying to use the UTFT Library with an Arduino Mega2560....I'm a bit strugling to know where to connect the 16bit parallel pins on the TFT board...
Posted by Rohalamin on Sat. Dec 20, 2014 - 06:05 PM
There's lots on YouTube...
Posted by unebonnevie on Sat. Dec 20, 2014 - 06:49 PM
Looking at a typical AS4.19 Makefile,   I notice: ## General Flags PROJECT = ahoesch MCU = atmega2560 TARGET = ahoesch.elf CC = avr-gcc CPP = avr-g...
Posted by slow_rider on Wed. Dec 17, 2014 - 11:54 AM
TPE wrote: why just use a flip flop to divide input clock by 2 and use this signal to TO ( input Timer0 max input f= 20MHz) ???  I always thought it was...

Buzzing Topics (Last 6 Months)

RSS

Posted by Michael@Atmel on Tue. Aug 26, 2014 - 12:04 AM
clawson wrote: Maybe its just me, but clicking on any links that I've found using google to "old" forum content just end up going to the home page of the new...
Posted by Hugh Aguilar on Fri. Oct 24, 2014 - 02:10 AM
Moderators - stop this train wreck now - please!
Posted by mado88 on Mon. Nov 10, 2014 - 03:38 PM
Clawson has true,   I was designed some peripheral boards for lifts - and it is not so simply. There are a lot of standards, norms and regulations. Lift...
Posted by ka7ehk on Fri. Jul 11, 2014 - 08:29 PM
Often a decaying average is enough. But if you do not want to have any historical data after a given number of sampls, the simple moving average is better...
Posted by dominicmluciano on Tue. Nov 11, 2014 - 05:42 PM
valusoft wrote:   microcarl wrote:    Two amplifiers, each with a total gain of approximately 27 would be nearly perfect: G = 5V / 185mV...
Posted by asking on Fri. Aug 15, 2014 - 08:35 PM
About a dozen messages ago, Lee askd you if the a/d reading was Nice and Smooth 0x000 to 0x7ff with a pot or something besides the current sensor. If it is,...