Recent Discussions

RSS

Posted by jgmdesign on Fri. Dec 19, 2014 - 09:12 PM
I spoke with the folks that want this and it would appear that this is not what was originally explained.  In fact it's IMO nutters to say the least....
Posted by pascalf on Sat. Dec 20, 2014 - 09:37 PM
Hi,   I tried to run the precompiled FW demo on the AT256RFR2-XPRO. I setup the board (fuse bit configuration)  and my PC with Putty for trying...
Posted by Heihopp on Sat. Mar 23, 2013 - 12:30 AM
http://www.lmgtfy.com?q=uc3+examples+tutorials
Posted by Nawfal on Thu. Mar 13, 2014 - 02:38 PM
Well,   looking at the libraries/UTFT folder,   hardware/avr/HW_atmega1280.h will contain the driver.     And VH goes...
Posted by thibaud22 on Thu. Dec 18, 2014 - 05:50 PM
Compiled as read-or-write, the above C statement could clear seven PORTD bits as well as toggling PORTD.0 No, writing to PIND would not clear bits in PORTD,...
Posted by ebrahim.rcii on Thu. Dec 18, 2014 - 07:14 AM
ebrahim.rcii wrote:No,I just want to learn something! For learning, it is usually best to start with the basics and work up - rather than leap straight into...

Buzzing Topics (Last 6 Months)

RSS

Posted by Michael@Atmel on Tue. Aug 26, 2014 - 12:04 AM
clawson wrote: Maybe its just me, but clicking on any links that I've found using google to "old" forum content just end up going to the home page of the new...
Posted by Hugh Aguilar on Fri. Oct 24, 2014 - 02:10 AM
Moderators - stop this train wreck now - please!
Posted by mado88 on Mon. Nov 10, 2014 - 03:38 PM
Clawson has true,   I was designed some peripheral boards for lifts - and it is not so simply. There are a lot of standards, norms and regulations. Lift...
Posted by ka7ehk on Fri. Jul 11, 2014 - 08:29 PM
Often a decaying average is enough. But if you do not want to have any historical data after a given number of sampls, the simple moving average is better...
Posted by dominicmluciano on Tue. Nov 11, 2014 - 05:42 PM
valusoft wrote:   microcarl wrote:    Two amplifiers, each with a total gain of approximately 27 would be nearly perfect: G = 5V / 185mV...
Posted by asking on Fri. Aug 15, 2014 - 08:35 PM
About a dozen messages ago, Lee askd you if the a/d reading was Nice and Smooth 0x000 to 0x7ff with a pot or something besides the current sensor. If it is,...