Recent Discussions

RSS

Posted by AdityaAVR on Tue. Dec 16, 2014 - 10:00 AM
What is the relation between F_CPU clock frequency and delay time? For the required delay in my code what should be the F_CPU in ATmega32? Is there any...
Posted by dhanushgowda on Sun. Dec 21, 2014 - 09:02 PM
it is my first project....... both ATmega16A and usbasp are brand-new.... i am using "Extreme Burner-AVR" in my PC to this job.... yes... PIN 10(Vcc) and PIN...
Posted by ka7ehk on Mon. Dec 22, 2014 - 12:22 AM
Jim,   I think best practice is to "un connect" the entire disk once the recording is stopped. so close all open files and unmount the disk.   now...
Posted by vj_25 on Sun. Dec 21, 2014 - 07:14 PM
Thanks for all your help guys. I did single step through the code and found everything to be okay, so I tried to remove all the debouncing stuff because I am...
Posted by baranikumarhtsl on Thu. Nov 22, 2007 - 08:04 AM
1. If reti() is explicitly mentioned in the code at the end of the isr block, even though the ISSR macro includes the reti() as discussed, will it cause any...
Posted by rajesh279 on Thu. Dec 18, 2014 - 01:34 PM
Yes,   that sounds fine. OTOH,  you could just use a single 10ms 'system' timer.   e.g. multiplex every tick,   read RTC on...

Buzzing Topics (Last 6 Months)

RSS

Posted by Michael@Atmel on Tue. Aug 26, 2014 - 12:04 AM
clawson wrote: Maybe its just me, but clicking on any links that I've found using google to "old" forum content just end up going to the home page of the new...
Posted by Hugh Aguilar on Fri. Oct 24, 2014 - 02:10 AM
Moderators - stop this train wreck now - please!
Posted by mado88 on Mon. Nov 10, 2014 - 03:38 PM
Clawson has true,   I was designed some peripheral boards for lifts - and it is not so simply. There are a lot of standards, norms and regulations. Lift...
Posted by ka7ehk on Fri. Jul 11, 2014 - 08:29 PM
Often a decaying average is enough. But if you do not want to have any historical data after a given number of sampls, the simple moving average is better...
Posted by dominicmluciano on Tue. Nov 11, 2014 - 05:42 PM
valusoft wrote:   microcarl wrote:    Two amplifiers, each with a total gain of approximately 27 would be nearly perfect: G = 5V / 185mV...
Posted by asking on Fri. Aug 15, 2014 - 08:35 PM
About a dozen messages ago, Lee askd you if the a/d reading was Nice and Smooth 0x000 to 0x7ff with a pot or something besides the current sensor. If it is,...